Model: TH-650W a product characteristic component, room temperature curing, white, cream, quick-drying; there is thermal bonding capabilities, strong bonding bonding, sealing, fixed, good strength, right??? The vast majority of metal and non-metallic materials with good adhesion, will not cause corrosion;? waterproof, anti-aging, anti-ultraviolet (not yellow), resistance to radiation, high and low temperature resistance to thermal shock;? insulation resistance Excellent voltage performance;? non-toxic, non-polluting, in line with the EU ROHS, HF, REACH environmental directives Second, application examples are widely used in electrical and electronic products, heat transfer adhesive electronic components, from the heat, fixed, insulated, shockproof , anti-corrosion effect. Typical applications include: bonding Positioning CPU processor and heat sink; the power LED, power transistors, thermistors, PTC adhesion heat transfer (heat). Third, technical indicators No. Test Item Specification Test Method cure an appearance before the white, cream visual dry time 2 min 3 ~ 10 TH-QC-002 tensile strength after curing 3 MPa ≥2.50 GB / T528-98 4 breaking elongation Long rate% 150 ~ 250 GB / T528-98 5 hardness JISA 45 ~ 55 GB / T531-99 6 shear strength MPa ≥2.80 GB / T7124-86 7 Volume resistivity Ω .cm ≥1.0 × 1015 GB / T1410-1989 8 Breakdown Voltage KV / mm 18 ~ 25 GB / T1408.1-99 9 permittivity 60HZ ≤3.0 GB / T1409-1988 10 dielectric loss factor of 60HZ ≤0.003 GB / T1409-1988 11 Thermal conductivity W / mk 1.20 GB /T8.140-82 use of methods first, clean the sticky surface, and then the amount of size, will be supporting the beak head cut off, the product can be extruded from the hose or play from the glue gun barrel with plastic applicator with plastic parts in the product can absorb trace moisture in the air from outside to inside gradually solidified into elastomer. The thicker the layer, the longer curing time, but try to layer thickness should not exceed 6mm, usually takes 24 hours to fully cure.